FLYFLY F86 SABRE 90mm DUCTED FAN JET!

Here is the new breed of electric ducted fan jets, an F86 Sabre with 1.4 metre wingspan! This Sabre has excellent detail, panel lines and mouldings are superb. Kit comes with all hardware, fixed Oleo struts with suspension, drop tanks, and will take a variety of electronics.

 

 

Designed to run 5 to 6 cell Lithium batteries, the performance is crisp with excellent climb and more than scale speed. The foam is dense and finely molded, much stiffer and stronger than your average foamy.

 

 

The stock 90mm fan is of good quality and runs well once it is properly balanced and set up, producing around 1.7kg thrust on 5 cells. Our EXP3300mah 5s1p 20c battery is minimum requirement, for much more power our ELITE 4000 5s1p 25c is recommended.

 

 

We will only be offering our Taiwan made 36mm motor for the stock fan as the available Chinese motors will not handle the high amp draw of the stock 7 blade units. Average amp draw is 52-55 on 5 cell packs, the cheaper Chinese motors pull 60 amps or more for less thrust.

 

 

The factory fan is less efficient and more amp hungry compared to a Wemotec fan, but it is a good budget setup.

 

 

FOR HIGH PERFORMANCE with less amp draw our WEMOTEC MIDIFAN ROTOR/ADPATER kit is a perfect fit to the stock housing. This gives you the less aggressive and far better designed Midifan which pulls fewer amps and allows popular 5 cell Midi setups such as our HET 600-32. For 6 cell setups the Midifan rotor matches perfectly with our Taiwan made HYK3660-1600 motor. Test results prove these to be an exceptional power system, the figures below tell the story:

 

MIDIFAN UPGRADE TEST RESULTS:

TYPHOON 600 series 5 cell: 18.5v / 59A / 1100W / 30,800rpm

 

The Typhoon setup is the best 5 cell setup we have available, producing almost identical output levels to the HYK only at higher amp draw. This is the choice setup for 5 cell.

 

HYK3660 1600Kv 6 cell: 22.3v / 50A / 1115W / 31,760rpm (results from inside the fuselage)

 

The HYK setup is the best 6 cell setup we have for a combination of amp draw vs power output, in the Sabre it is good for around 90mph! (dependant on battery used)

 

Forget about expensive turbine jets which require permits and engineering certificates to own, forget about noisy glow powered fans, this is the way of the future! High quality EPS foam aircraft with high powered 90mm fan units, the affordable large jet!

 

F86 SABRE SPECIFICATIONS

The F86 Sabre is made from hi impact EPS foam, scale undercarriage, drop tanks and 90mm fan included. Optional retract kit is spring air operated, air up, spring down. Retracts drop into the stock undercarriage position and finish off what is a superb large foamie! Add one of our large jet pilots for that super scale look!

 

NOTE: We have an upgrade kit available that replaces the very stiff plastic air valve with a precision machined alloy one and adds quick release valve and fittings for removing the wing. Details are on the RETRACT PAGE

 

 

RC FUNCTIONS:

- Ailerons

- Elevator

-Throttle

- Rudder (optional)

- Retracts (optional)

SPECIFICATIONS:
Wing Span                        1420mm
Length                              1410mm

Weight (RTF)                     2.3 ~ 2.7kg

EDF unit                            90mm ducted fan

Motor                                HYL3660 or HET600 series

Battery                              3300-4000mah 5s-6s

ESC                                  LIGHTNING 60A/80A

                                        X-Power 60A/100A OPTO

Servos                              9-18 gram high torque BB

 

        

OLEO STRUTS                        AIR RETRACTS

OUR SABRE IN BLACK DIAMONDS MARKINGS

Running HYK3660 motor with 4000mah 6s1p battery, LIGHTNING 60A ESC, 2.85kg flying weight.

 

HAND LAUNCH VIDEO OF SABRE!

Same power system as first video, no undercarriage, alloy film covering, 3.0kg flying weight!

 

We are now producing custom vinyl decals for popular Australian Aerobatic Team schemes. Our professional sign writer has created multi layered decals from our files, these are superb looking sticker sets, a bit more care is needed when applying them but the results are numbers with no borders, and complex graphics that finish the aircraft!

AUSTRALIAN BLACK DIAMONDS

 

F86 SABRE:

PRICE

STATUS

SABRE 90mm kit with scale sprung undercarriage and 90mm fan unit

$250.00

IN STOCK

HYK3660 1600 motor for 6 cell setups

$109.00

IN STOCK

HET TYPHOON 600-32 motor for 5 cell setups

$109.00

IN STOCK

WEMOTEC Midifan PRO rotor & shaft adapter kit

$60.00

IN STOCK

Spring-Air retract set to suit SABRE (This price only when ordered with kit)

$90.00

IN STOCK

 

AUSTRALIAN Black Diamonds decal set

$30.00

NO STOCK

 

RECOMMENDED BATTERY PACKS

PRICE

STATUS

EXTREME POWER EXP 3300mah 5s1p 20c

$149.00

IN STOCK

EXTREME POWER EXP 3300mah 6s1p 20c

$174.00

IN STOCK

EXTREME POWER ELITE 4000mah 5s1p 25c

$210.00

DUE END OCT

EXTREME POWER ELITE 4000mah 6s1p 25c

$240.00

DUE END OCT

 
HOME
 
©2008 EXTREME RADIO CONTROL AUSTRALIA