Newest version of the CS Electric retracts to suit our FlyFly 90mm foam jets and will suit many other model up to 4kg flying weight. A great low cost setup that requires no extra servos, just connect to your retract switch and adjust end points to suit! NOTE: This is the Nose retract with steering arm and 5mm pin, order this with the mains when you want a tricycle set. We have strut and wheel sets to suit these retracts in the struts page.

RETRACT FEATURES:

• 3 seconds overcurrent/jamming protection
• Auto recovery after overcurrent and jamming protection
• Smart circuit to prevent retract unit from accidentally retracted even if you connect power to the plane with your TX set to retract the landing gear.
• Front retract comes with steering arm built in.
• Use carefully with models heavier than 4.0kg
• Voltage 4.8-6V
• Working current 0.3-0.6A
• Mounting hole spacing: 36W x 33L
• Mounting plate dimensions: 44W x 41L
• Depth: 26mm
• Overall length: 75mm
• Width between rails: 21mm
• Trunion height from mounting plate approx. 3mm.