Sales Message Goes Here

MACHINED BRASS PROP NUT 100-150G

$44.00

Custom machined solid brass prop nut for your outrunner! This is the large series nut with M10x1.0mm thread, this is very common thread for the large outrunners sold by most motor brands. We can also cut M10x1.5mm, M8x1.0/1.5mm and 12mm thread for the larger prop shafts.

NOTE: You will need to specify the thread size & pitch of your adapter shaft during checkout, if you are unsure of your prop shaft thread email a photo across or you can even mail your prop adapter in so we can match it up for you!

The size of this prop nut is approx' 28mm diameter and will range from 25-35mm long. To work out what weight you need add weight to the front of your prop until you balance your model then we use that weight as a guide for your prop nut.

As this is a custom part hand made in our machine shop it will be within a few grams of your specified weight, usually only a gram or so tolerance. Bear in mind the cost covers solid brass billet, lathe setup time and machining/finishing, there is over an hour of work in these nuts!


  • Shipping Weight: 0.2kgs
  • 5 Units in Stock


This product was added to our catalog on Friday 13 April, 2018.