Sales Message Goes Here

HYPERION Z5045-16

$399.00  $196.00
Save: 51% off

5045 NOW SOLD OUT GUYS! WE ARE WORKING ON A CUSTOM 6364 SIZE EXTREME OUTRUNNER HAND WOUND IN HOUSE HERE IN OZ BY YOURS TRULY, 162Kv AND 670 GRAMS, WILL SWING A 24x10 PROP ALL DAY ON 12s, STAY TUNED!

All factory fittings are included, some steel fittings like collets may have surface rust, this is typical of all Hyperion 50 series accesories. These old Z50 series Hyperion were extremely well built motors and very efficient, they don't make them like this anymore!

Hyperion Z5045 Outrunner Motor Series for Large Electric Models and IC Engine Conversions.

The new Z50 Series Hyperion Outrunners are big brothers to the excellent Z40 motor series, and share their quality in materials and design. From front to back, only the highest quality materials and components are used. The arrangement of twelve stator poles and fourteen magnet poles is primarily responsible for the high torque the Z50 Series generates on direct drive.

But there is much more to the "Z" than that. The stators are hand-wound in an optimal pattern for copper packing, so we get less resistance for a given number of turns. The stator plates are produced via a CNC process that insures uniformity, and made of the latest Japanese silicon steel with superior permeability at high induction, which makes the motors run more efficiently. The stator plates are finished with a lifetime anti-oxidant coating, to eliminate losses which can occur due to magnetic shorting from corrosion.

The magnets are especially made for the Z Series motors, and are rounded on both bell and stator sides. The result is that contact area with the bell is complete, and this has two benefits: First, heat transfer is maximized, so the magnets are much less subject to damage from overheating.

Second, the full contact with the bell on one side, and matching curvature to the stator on the other, means that the magnetic flux lines are complete and optimally shaped; this means higher efficiency, lower incidence of motor stalling, and smoother starts. The magnets themselves are produced in one of the foremost factories in the world, and are the latest type, featuring both an extremely high temperature rating and high magnetic strength. They are retained by fingers in the bell-end, and attached with a special high-temp glue. Finally, the high-speed, shielded stainless bearings in the Z50 Series are made by NMB Japan; expensive for Hyperion to install, but well worth it for smoothness and longevity.

One of the most important design features of the Z50 series is the large ring bearing which supports the rotating bell at the front of the motor. During the development process on the Z40 series, we found that many failures of large OutRunner motors can be traced to deformation in the bell at higher rpm. By installing this ring bearing in the Z5025 to Z5045 motors, we fully support the bell both at front and back of the motor, and therefore greatly reduce the chances of magnet-adhesion failures.

  • Max Efficient Current 40~60A
  • Max Peak 20 Sec 75A
  • Sugg. Power Range 1700W ~ 2150W (3000W 3D max peak, 10 seconds)
  • Sugg. Input Voltage 10S~12S
  • Io (@8.4V): (A)1.8A
  • KV: (rpm/V) 168
  • Ri: (ohm) 0.018
  • Sugg MAX Prop Size: 20x12E 12S
  • Weight: 800 grams
  • Motor Diameter: 59mm
  • Motor Length: 81mm
  • Shaft Diameter: 8mm

  • Shipping Weight: 0.98kgs
  • 0 Units in Stock


This product was added to our catalog on Tuesday 22 June, 2010.