Newest version of the CS Electric retracts to suit our FlyFly 90mm foam jets and will suit many other models 3-4.5kg flying weight. With care they should be fine on 5kg models but hard landings can break the casing. A great low cost setup that requires no extra servos, just connect to your retract switch and adjust end points to suit! This is a pair of mains good for tail dragger models, no pins included, they usually come with your struts, we use 5mm piano wire when needed.
RETRACT FEATURES:
- 3 seconds overcurrent/jamming protection
- Auto recovery after overcurrent and jamming protection
- Smart circuit to prevent retract unit from accidentally retracted even if you connect power of the plane when the RC control was set to retract the landing gear. Protect your plane from scratch or damage.
- Front retract comes with steering arm built in.
-
- Use carefully with models heavier than 4.0kg
- Voltage 4.8-6V
- Working current 0.3-0.6A
- Mounting hole spacing: 36W x 33L
- Mounting plate dimensions: 44W x 41L
- Depth: 26mm
- Overall length: 75mm
- Width between rails: 21mm
- Trunion height from mounting plate approx. 3mm.
![Powered by Zen Cart :: The Art of E-Commerce [home link]](includes/templates/classic/images/logo.gif "Powered by Zen Cart :: The Art of E-Commerce [home link]"){kind=logo}