Sales Message Goes Here



Newest version of the CS Electric retracts to suit our FlyFly 90mm foam jets and will suit many other model up to 4kg flying weight. A great low cost setup that requires no extra servos, just connect to your retract switch and adjust end points to suit! NOTE: This is the Nose retract with steering arm and 5mm pin, order this with the mains when you want a tricycle set. We have strut and wheel sets to suit these retracts in the struts page.


  • 3 seconds overcurrent/jamming protection
  • Auto recovery after overcurrent and jamming protection
  • Smart circuit to prevent retract unit from accidentally retracted even if you connect power to the plane with your TX set to retract the landing gear.
  • Front retract comes with steering arm built in.
  • Use carefully with models heavier than 4.0kg
  • Voltage 4.8-6V
  • Working current 0.3-0.6A
  • Mounting hole spacing: 36W x 33L
  • Mounting plate dimensions: 44W x 41L
  • Depth: 26mm
  • Overall length: 75mm
  • Width between rails: 21mm
  • Trunion height from mounting plate approx. 3mm.

  • Shipping Weight: 0.4kgs
  • 4 Units in Stock

This product was added to our catalog on Tuesday 28 January, 2014.